CL Command Reference - ADDRJEWTRE
CL Command List > ADDRJEWTRE Reference
Description:
The ADDRJEWTRE command adds a writer entry to an existing session description. If an entry is added to a session description while the session is active, the change does not take effect until the session is ended and started again.
Each SNA writer entry can point to a single communications entry, although for performance reasons this method is not recommended. Each writer entry for BSC requires a corresponding communications entry as described in the ADDRJECMNE command.
The maximum number of writers supported depends on the host subsystem. For SNA, RJE supports up to 15 printers and 15 punches. The total number of printers and punches is 30, depending on the host subsystem. For BSC, RJE supports up to seven printers and seven punches, but the total number of writers cannot exceed eight.
Several parameters of the writer entry can affect the processing of an output stream if any of the following conditions are true:
. An FCT is not associated with the RJE session description
. The PDIR or form-mount message from the host subsystem specifies a form type that does not exist as an entry in the FCT
. The value *WTRE is specified for the FILE parameter of the FCT entry
. The value *NONE is specified for the FILE parameter of the FCT entry
. The default value of *WTRE is specified for any of the optional parameters of the Start RJE Writer (STRRJEWTR) command.
The parameter values specified for this writer entry can be overridden by parameter values specified in the STRRJEWTR command.
Examples:
None.